Filter
Top Products
Commands Listed in Alphabetical Order
Conditions
This command re
quires a DPO4COMP application module.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:RS232C: CONDition
{RXSTArt|RXDATA|RXENDPacke t|TXSTArt|TXDAT A|TXENDPacket}
TRIGger:A:BUS:B<x>:RS232C: CONDition?
Arguments
RXSTArt specifies a search based on the RX Start Bit.
RXDATA specifies a search based on RX Data.
RXENDPacket specifies a search based on the RX End of Packet condition.
TXSTArt specifies a search base on the TX Start Bit.
TXDATA specifies a search based on TX Data.
TXENDPacket specifies a search based on the TX End of Packet condition.
TRIGger:A:BUS:B<x>:RS232C:RX:DATa:SIZe
Sets or returns the length of the data string in Bytes for an RS-232 Trigger if the
trigger condition i s RXDATA. Applies to bus <x>, where x is the bus number.
Conditions
This command requires a DPO4COMP application module.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:RS232C: RX:DATa:SIZe <NR1>
TRIGger:A:BUS:B<x>:RS232C: RX:DATa:SIZe?
Arguments
<NR1> is th
e length of the data string in bytes.
TRIGger:A:BUS:B<x>:RS232C:RX:DATa:VALue
Sets or returns the binary data string for an RS-232 trigger if the trigger condition
involves
RX. Applies to bus <x>, where x is the bus number.
Conditions
This command requires a DPO4COMP application module.
MSO4000 and DPO4000 Series Programmer Manual 2-421