Operating Basics: User Interface
OTS9100 User Manual 2-41
Figure 2-25: Edit K1, K2 Bytes dialog box
For K1, type in the channel being set and click on the Request pull-down menu to select the new
value. The values available from the pull-down menu are:
• (0) No Request
• (1) Do Not Revert
• (2) Reverse Request
• (3) Unused
• (4) Exercise
• (5) Unused
• (6) Wait to Restore
• (7) Unused
• (8) Manual Switch
• (9) Unused
• (10) Signal Degrade, Low Priority
• (11) Signal Degrade, High Priority
• (12) Signal Fail, Low Priority
• (13) Signal Fail, High Priority
• (14) Forced Switch
• (15) Lockout of Position
For K2, type in the bridged channel being set then use the pull-down menus to select the
architecture and mode. The values available from the architecture pull-down menu are:
• (0) 1 + 1
• (1) 1 + N