Filter
Top Products
Optical Card Front Panel Descriptions
OTS9100 User Manual B-3
Optical IN
The Optical IN port accepts the incoming optical signal to the receiver.
This input signal must have a wavelength between 1290 nm and 1565
nm and must not exceed 0dBm of power.
The LED labeled SIG PRES above the OPTICAL IN heading will turn
green when the Optics card detects an incoming signal. Flashing Red
indicates an optical loss of signal (LOS) condition, and flashing amber
indicates an optical overload condition.
WARNING: The incoming signal must be attenuated to within specified
power levels. If the signal exceeds 0 dBm, damage may occur.
Rx DATA OUT
Rx DATA OUT provides signal interconnection between the system
cards.
This output must be connected to the Rx DATA IN port found on the
Receive card of the OTS9100 system using the coax cable and DC block
provided.
Rx DATA OUT
Rx DATA OUT is a 10Gb/s DATA Signal provided for jitter
measurement.
This output must be connected to the 10 Gb/s DATA IN port found on
the OTS92H1 Clock Receiver Card using the coax cable provided (no
DC block is necessary). Otherwise, this output is normally terminated
with 50Ω.