Filter
Top Products
Reference: Remote Commands ~ Command Description
OTS9100 User Manual 3-33
:SENSe:INPUt:THREshold
This command sets the receiver input offset threshold value in millivolts for the OTS receiver. The query
form returns the current setting.
Syntax :SENSe<slot>:INPUt:THREshold?
:SENSe<slot>:INPUt:THREshold <NR1>
:SENSe:INPut:THReshold:LOS
This command sets the LOS threshold value. The query form returns the currently active setting for the
LOS threshold.
Syntax :SENSe<slot>:INPut:THReshold:LOS?
:SENSe<slot>:INPut:THReshold:LOS <NR1>
:SENSe:MEASure:APSTime:CONDition
This command sets the condition tested for APS switch time measurement. The query form returns the
current setting
Syntax: :SENSe<slot>:MEASure:APSTime:CONDition?
:SENSe<slot>:MEASure:APSTime:CONDition <Enum>
Parameters Description
LOS Loss of Signal
OOF Severely Errored Frame / Out of Frame
B1BIP B1 errors
B2BIP B2 errors
B3BIP B3 errors
BIT Bit (payload) errors
AIS_L Line AIS / MS-AIS
AIS_P Path AIS
RDI_L Line RDI / MS-RDI
RDI_P Path RDI