Filter
Top Products
Getting Started
1-4 OTS9100 User Manual
Accessories
Accessories included with the OTS9100 module are provided in the following list. If you wish
to purchase optional accessories contact your local Tektronix Representative.
Standard with each shipment
Certificate of Traceable Calibration
119-6364-11 OTS9000 Software CD
063-3560-03 OTS9100 User Manual CD
071-1060-03 OTS9100 Installation Guide
NOTE: DC Blocks are provided for use in two instances only. The first being, one DC Block must
always be connected to the OTS91R2 Receive Card at the Rx interface port in all OTS9100
modules (see Figure 1-3 for cabling illustration).
The second is in regard to use with the Transmit interconnection when using earlier versions of
the optics cards; the OTS91L1, OTS91L2 and the OTS91L3, the earlier optics cards will require
that a DC Block be connected to the Tx DATA OUT interface port.
DO NOT ATTACH A DC BLOCK TO THE OTS91T3 WHEN USING OTS91L4, OTS91L5,
OTS91L6, OTS91L7 OR OTS91L8, DEGRADATION WILL OCCUR.
Each of the optical cards requires a specific set of accessories. Additional items are listed by
each card type below.
OTS91L4 Standard
174-4702-00 6” coax cable (one included with shipment)
174-4277-01 8” coax cable (one included with shipment)
OTS91L5 Standard
174-4702-00 6” coax cable (one included with shipment)
OTS91L6 Standard
174-4702-00 6” coax cable (one included with shipment)
174-4277-01 8” coax cable (one included with shipment)