Filter
Top Products
Reference: Remote Commands ~ Commands Overview
OTS9100 User Manual 3-3
Save and Restore System Settings
These commands provide the save and restore functionality for system level settings.
*SAV
*RCL
:system:description:setup
System File Management
These commands define the necessary settings to allow the system to delete old files thus preventing
performance degradation due to lack of memory.
:system:files:mgmt:results
System Signal Standard (OTS9100 module)
This command sets all system modules to the SONET or SDH signal standard.
:system:signal:standard
Receiver Commands (OTS9100 module)
These commands provide configuration and control of the receiver settings.
Signal standard :sense:signal:standard
Receiver input threshold :sense:input:threshold
Line rate :sense:data:rate
Signal structure :sense:data:structure
Active payload channel :sense:data:channel
Payload data :sense:data:payload:pattern
Generate trigger on anomaly or defect received :sense:trigger:mode
Received signal status :sense:status:leds
J0 section trace received :sense:data:section:trace
J0 section trace comparison value :sense:analysis:section:trace
J1 path trace received :sense:data:path:trace
J1 path trace comparison value :sense:analysis:path:trace
Path label mismatch :sense:data:poh:hpplm
:sense:data:poh:c2a:byte
Overhead monitor channel selection :sense:overhead:monitor:channel
Transport overhead data received :sense:data:toh
Receiver Optics :sense:optical