Filter
Top Products
Operating Basics: User Interface
2-26 OTS9100 User Manual
Transmitter – Signal
The Signal Property menu of the Transmitter setup, as shown in Figure 2-10, provides the
controls for selecting the Signal setup, Transport overhead, Path overhead, Error insertion, K1,
K2 Decode, IP payload and IP error. In addition, the signal structure and test pattern for both the
active channels and the background channels are configured on this setup menu. Each of the
selections available is described in more detail in the following sections.
Figure 2-10: Transmitter Setup – Signal menu
Signal Standard
Signal Standard selects the operating mode of the transmitter. To select either SONET or SDH
mode, click on the pull-down menu and select the desired operating mode. The operating mode
may also be selected via the menu bar. Click on System – Signal Standard and select either Set
to SONET or Set to SDH.
NOTE: If the signal standard is selected via the menu bar (View>Options), the signal standard is
set for all devices in the system.