Filter
Top Products
Reference: Remote Commands ~ Command Description
OTS9100 User Manual 3-75
:SYSTem:COMMunicate:SERIal:COM2A:RTS
This command controls the state of the RTS (Request to Send) control signal on the COM2 port. It has no
effect when hardware flow control is enabled. The query form returns the current setting.
Syntax :SYSTem:COMMunicate:SERIal:COM2A:RTS?
:SYSTem:COMMunicate:SERIal:COM2A:RTS <Boolean>
:SYSTem:COMMunicate:SERIal:COM2A:RXTERM
This command selects, for the COM2 serial port, the character the OTS-9000 system recognizes as End-
of-Input. The query form returns the current setting.
Syntax :SYSTem:COMMunicate:SERIal:COM2A:RXTERM?
:SYSTem:COMMunicate:SERIal:COM2A:RXTERM <Enum>
Parameters Description
LF Line feed (LF) character, 0x0A; an optional preceding CR is ignored
CR Carriage return (CR) character, 0x0D; an optional preceding LF is ignored
:SYSTem:COMMunicate:SERIal:COM2A:TXTERM
This command controls, for the COM2 serial port, the characters the OTS-9000 system sends at the end
of a query response. The query form returns the current setting.
Syntax :SYSTem:COMMunicate:SERIal:COM2A:TXTERM?
:SYSTem:COMMunicate:SERIal:COM2A:TXTERM <Enum>
Parameters Description
LF Line feed (LF) character, 0x0A
CR Carriage return (CR) character, 0x0D
CRLF CR followed by LF
LFCR LF followed by CR
:SYSTem:CONFig:MODule:SERIAL
This query accepts a module slot number, between 1 and 16, and returns a string identifying the
Tektronix module card serial number as a quoted string.
Syntax :SYSTem:CONFig:MODule:SERIAL? <NR1>