Filter
Top Products
Reference: Remote Commands ~ Command Description
3-68 OTS9100 User Manual
:SYSTem:COMMunicate:PORT:RXTERM
This command selects, for the current remote-control port, the character the OTS system recognizes as
End-of-Input. The query form returns the current setting.
Syntax :SYSTem:COMMunicate:PORT:RXTERM?
:SYSTem:COMMunicate:PORT:RXTERM <Enum>
Parameters Description
LF Line feed (LF) character, 0x0A; an optional preceding CR is ignored
CR Carriage return (CR) character, 0x0D; an optional preceding LF is ignored
:SYSTem:COMMunicate:PORT:TXTERM
This command controls, for the current remote-control port, the characters the OTS system sends at the
end of a query response. The query form returns the current setting.
Syntax :SYSTem:COMMunicate:PORT:TXTERM?
:SYSTem:COMMunicate:PORT:TXTERM <Enum>
Parameters Description
LF Line feed (LF) character, 0x0A
CR Carriage return (CR) character, 0x0D
CRLF CR followed by LF
LFCR LF followed by CR
:SYSTem:COMMunicate:SERIal:COM1A:DTR
This command controls the state of the DTR (Data Terminal Ready) control signal on the COM1 port. The
query form returns the current setting.
Syntax :SYSTem:COMMunicate:SERIal:COM1A:DTR?
:SYSTem:COMMunicate:SERIal:COM1A:DTR <Boolean>