Filter
Top Products
Reference: Remote Commands ~ Command Description
3-80 OTS9100 User Manual
:SYSTem:LOCK:RELease
This command releases the lock set by a :SYSTEM:LOCK:REQUEST operation. The lock must have
been set by the same user; an attempt to release a lock set by another user will not succeed. If no lock is
set this command is ignored.
Syntax :SYSTem:LOCK:RELease
:SYSTem:LOCK:RELease:FORCE
This command releases any lock set by a :SYSTEM:LOCK:REQUEST operation or any corresponding
user-interface operation.
Syntax :SYSTem:LOCK:RELease:FORCE
:SYSTem:LOCK:REQuest
This query attempts to lock' the system interface, ie, to take exclusive control of the system for commands
that change system settings ('set' commands). It returns 1 if the lock succeeds, 0 if it fails.
Syntax :SYSTem:LOCK:REQuest?
:SYSTem:SIGNal:STANdard
This command sets the OTS9100 system to the SONET or SDH signal mode. The query form returns the
current setting.
Syntax :SYSTem:STANdard?
:SYSTem:STANdard SONET SDH
Parameters Description
SONET Set system to SONET signal mode
SDH Set system to SDH signal mode