Filter
Top Products
Reference: Remote Commands ~ Command Description
3-72 OTS9100 User Manual
:SYSTem:COMMunicate:SERIal:COM1A:TXTERM
This command controls, for the COM1 serial port, the characters the OTS system sends at the end of a
query response. The query form returns the current setting.
Syntax :SYSTem:COMMunicate:SERIal:COM1A:TXTERM?
:SYSTem:COMMunicate:SERIal:COM1A:TXTERM <Enum>
Parameters Description
LF Line feed (LF) character, 0x0A
CR Carriage return (CR) character, 0x0D
CRLF CR followed by LF
LFCR LF followed by CR
:SYSTem:COMMunicate:SERIal:COM2A:DTR
This command controls the state of the DTR (Data Terminal Ready) control signal on the COM2 port.
The query form returns the current setting.
Syntax :SYSTem:COMMunicate:SERIal:COM2A:DTR?
:SYSTem:COMMunicate:SERIal:COM2A:DTR <Boolean>
:SYSTem:COMMunicate:SERIal:COM2A:ECHO
This command controls, for the COM2 serial port, how the system echoes the characters it receives. The
parameter is a numeric value containing three individual control bits. The query form returns the current
setting.
Syntax :SYSTem:COMMunicate:SERIal:COM2A:ECHO?
:SYSTem:COMMunicate:SERIal:COM2A:ECHO <NR1>
Bit value Function
0 Disables (0) echo
1 Enables (1) echo
2 Causes the input terminator character to be echoed as CR-LF
4 Enables input line buffering: received characters are not processed until the terminating
CR or LF
:SYSTem:COMMunicate:SERIal:COM2A:ENABle
This command enables or disables the operation of serial port COM2 as a remote control port. The query
form returns the current setting.
Syntax :SYSTem:COMMunicate:SERIal:COM2A:ENABle?
:SYSTem:COMMunicate:SERIal:COM2A:ENABle <Boolean>