Filter
Top Products
Reference: Remote Commands ~ Commands Overview
3-2 OTS9100 User Manual
Remote Control Port Settings
These commands provide the GPIB, Serial, and network port setups as well as the serial and network port
protocols.
GPIB port setup :system:communicate:gpib:primary
:system:communicate:gpib:secondary
COM1 serial port setup
enable
baud rate
number of data bits
number of stop bits
flow control mode
parity
RS-232 DTR line
RS-232 RTS line
:system:communicate:serial:com1a:enable
:system:communicate:serial:com1a:rate
:system:communicate:serial:com1a:ndata
:system:communicate:serial:com1a:nstop
:system:communicate:serial:com1a:flow
:system:communicate:serial:com1a:parity
:system:communicate:serial:com1a:dtr
:system:communicate:serial:com1a:rts
COM2 serial port setup :system:communicate:serial:com2a: ... as above
Network port connect address :system:communicate:network:ipport
COM1 serial port protocol
echo control
prompt
input terminator
output terminator
:system:communicate:serial:com1a:echo
:system:communicate:serial:com1a:prompt
:system:communicate:serial:com1a:rxterm
:system:communicate:serial:com1a:txterm
COM2 serial port protocol
:system:communicate:serial:com2a: ... as above
Network session protocol, initial values
:system:communicate:network: ... as above
Current serial or network port session protocol
:system:communicate:port: ... as above
Remote Control Lockout
These commands enable remote control lockout.
:system:lock:request
:system:lock:release
System Configuration Queries
These commands provide the ability to query the modules installed in the OTS9100 system to determine
what configurations are installed.
:system:config:module:slots
:system:config:module:type
:system:config:module:version
:system:config:module:variant
:system:config:module:serial