Filter
Top Products
Optical Card Front Panel Descriptions
2-4 OTS9100 User Manual
10 Gb/s TRANSMIT-ONLY OPTICS CARD
(L5-15, L5-13)
The 10Gb/s Optical Transmit-only card is available with two laser
options:
1310 nm or 1550 nm. This Optics card performs E/O conversion and
works in conjunction with the Transmit card, which contains transmitter
functionality for the OTS9100 system.
Figure B-2 shows the Transmitter Optics card front panels.
Module OK
The Module OK LED should be green while the instrument is running.
On power up, the LED first lights red, then changes to green when the
system has finished initializing.
NOTE: If the LED remains red after the system has finished initializing
or fails to light at all, call Tek service.
Optical OUT
The Optical Output emits an optical data signal at a wavelength of 1310
nm or 1550 nm, with the proper option. The optical connector can be
configured with field interchangeable shells: FC(standard), ST, or SC
type. The field interchangeable shells are easily removed to allow easy
cleaning of the connector interface.
The LED located above the Optical OUT heading will flash amber for
five seconds and then turn green when the laser is activated.
NOTE: If the LED flashes red, continues to flash amber, or fails to light
at all, call Tektronix for service.
WARNING: Always avoid exposure to the laser beam. Before power
is applied to the OTS9100 system, be sure that all laser outputs are
either covered with the screw cap provided or connected to
the appropriate circuit.
Figure B-2:
Transmitter Front Panels