Filter
Top Products
Getting Started
1-8 OTS9100 User Manual
When the card is in place, tighten the two screws to secure it.
CAUTION! Do not torque the screws with more than 2 in-lbs of force or damage will occur.
5. Verify that the power switch of the OTS chassis is in the OFF position.
6. Plug the unit into the appropriate AC Power source as follows:
Table 1-4: Power Requirements
AC Voltage Voltage Range Frequency Range
110 VAC 90 VAC - 132 VAC 48 - 62 Hz
220 VAC 180 VAC - 250 VAC 48 - 62 Hz
Removing Cards
To remove the OTS cards, perform the following steps:
1. Turn off the power.
2. Fully loosen the two screws found on the top and bottom of the card.
3. Push up on the top release and down on the bottom release until the card is released from the
connectors.
4. Carefully slide the card out of the slot.
NOTE: If a card is removed, a blanking panel and air diverter must be installed to ensure
proper airflow through the system. Failure to replace the air diverter and blanking panel could
cause the system to overheat.