Filter
Top Products
OTS9100 User Manual F-1
Installing the Software
These instructions explain how to load the software. The OTS90x0 system is shipped with the
software pre-loaded. This procedure should only be required if the software is accidentally
wiped off the hard drive or if you receive a system software upgrade.
NOTE: The installation software will first remove any previous versions of the OTS90x0 system
software prior to loading the new version. Since this involved a restarting the computer, it is
recommended that all programs be closed prior to performing the installation.
1. Remove the OTS90x0 CDrom from its case and place the CDrom into the OTS90x0 CDrom
drive.
2. The CDrom setup program should start automatically. If it does not, click Start, Run, and type
in “<CDrom drive letter>:\setup.exe”.
3. Follow the prompts to install the new version of the software.
4. When the software is finished loading, remove the CDrom and place it in its case.