TP-6200 10/12 69Section 2 Operation
2.7.14 Menu 14—Programming Mode
Menu 14 provides local or remote access to the
programming function. The user enters a password to
access the programming mode.
Note: Log into the local programming mode to edit the
programming access code. The factory default
access code is the number 0.
Use Menu 14 to change the access code. Record the
new number and give the access code only to
authorized individuals. Should the controller logic not
accept the access code or if the new code number is lost,
contact your local authorized distributor/dealer for
password information.
The user chooses one of three programming modes:
D Local—using the controller keypad
D Remote—using a PC
D Off—no programming is permitted
Note: Use the generator set controller to initially set up
remote programming. Remote programming
cannot be accessed from a PC unless the
controller is first set for remote programming
using Menu 14.
See Section 2.8.14.
MENU 14
PROGRAMMING MODE
PROGRAMMING MODE →
LOCAL Y/N
PROGRAMMING MODE →
CHANGE ACCESS CODE
PROGRAMMING MODE →
REMOTE Y/N
PROGRAMMING MODE →
ENTER OLD CODE #
PROGRAMMING MODE →
OFF Y/N
Menu 14 Overview
PROGRAMMING MODE →
ENTER NEW CODE #