TP-6200 10/12 67Section 2 Operation
2.7.12 Menu 12—Calibration
Menu 12 provides access to the calibration factors for
metering (volts and amps) and auxiliary analog inputs.
Changing the system voltage or replacing the main logic
control circuit board requires calibration adjustment.
The user must enable the programming mode to edit the
display.
See Section 2.8.12 to make calibration changes.
MENU 12
CALIBRATION
SCALE AC ANALOG
INPUTS
GEN VOLTAGE LN
TO SCALE AUX. ANALOG
INPUTS SETUP (NEXT)
GEN AMPS LOAD VOLTAGE LN
Menu 12 Overview
RESTORE DEFAULTS Y/NGEN VOLTAGE LL
GEN L1--L0 V #
CALIB REF ?
GEN L1 AMPS #
CALIB REF ?
LOAD L1--L0 V #
CALIB REF (PARALLEL) ?
GEN L1--L2 V #
CALIB REF ?
GEN L2--L0 V #
CALIB REF ?
GEN L2 AMPS (3 PHASE)#
CALIB REF ?
LOAD L3--L0 V #
CALIB REF (PARALLEL) ?
GEN L2--L3 V (3 PHASE) #
CALIB REF ?
GEN L3--L0 V (3 PHASE) #
CALIB REF ?
GEN L3 AMPS (3 PHASE)#
CALIB REF ?
GEN L3--L1 V (3 PHASE) #
CALIB REF ?
CALIBRATE REGULATOR?
Y/N
SCALE AUX. ANALOG
INPUTS
ZERO AUX. ANALOG
INPUTS? Y/N
TO AC ANALOG INPUTS
SETUP (PREVIOUS)
SCAL1 #V
SCAL2 #V
Press YES or NO. Text
appears on display lower line.
Pressing ENTER confirms
YES or NO selection.
ANALOG XX #
SCALE VALUE 1 ?
SCAL 1 # V
SCAL 2 # V
ANALOG XX #
SCALE VALUE 2 ?