Filter
Top Products
TP-6200 10/1266 Section 2 Operation
2.7.11 Menu 11—Voltage Regulator
Menu 11 displays setup of the voltage regulator functions
including line-to-line voltages, underfrequency unloading
(volts per Hz), reactive droop, power factor, and kVAR
adjustments.
The user must enable the programming mode to edit the
display.
See Section 2.8.11 to make changes in this menu.
Note: The individual line-to-line voltages are displayed
for review purposes only.
Note: Voltage regulator gain is used for adjusting
voltage stability and/or response.
Note: Utility gain is used for VAR or PF stability adjust
while paralleling to a utility.
MENU 11
VOLTAGE REGULATOR
AVG L-L V # →
VOLT ADJ ?.?
UNDER FREQ UNLOAD →
ENABLED Y/N
REACTIVE DROOP →
ENABLED Y/N
VAR CONTROL →
ENABLED Y/N
PF CONTROL →
ENABLED Y/N
L1-L2 VOLTS →
#
FREQUENCY # HZ→
SETPOINT ?.? HZ
.8 PF RATED LOAD →
VOLTAGE DROOP ?.?%
TOTAL KVAR # →
KVAR ADJ ?.?
AVERAGE PF # →
PF ADJ ?.?
L2-L3 VOLTS (3 PHASE) →
#
SLOPE →
?.? VOLTS-PER-CYCLE
Menu 11 Overview
L3-L1 VOLTS (3 PHASE) →
#
GENERATING/ Y/N→
ABSORBING Y/N
LAGGING/ Y/N→
LEADING Y/N
REGULATOR GAIN ADJ
GAIN #
UTILITY GAIN ADJUST
GAIN #
ANALOG VOLTAGE ADJUST
ENABLED Y/N
RESET REGULATOR
DEFAULTS? Y/N