Kohler 20-3250 kW Portable Generator User Manual


 
TP-6200 10/12 135Section 2 Operation
Local Programming Mode On
2.8.16 Menu 20—Factory Setup
Menu 20 provides generator set, alternator, controller,
and engine identification information. The user can use
this menu to determine the generator set operating days
and identify the controller software (code) version. The
factory s etup menu information is locked by the
manufacturer. The temperature sensor setup applies to
non-ECM engines only.
Note: This menu is for monitoring only; no adjustments
or user settings can be entered.
Note: For Version 2.69 and lower, enter the numeric
serial number from the generator set nameplate.
For Version 2.70 and higher, confirm that the
alphanumeric number shown on the display
matches the serial number shown on the
generator set nameplate. If the serial
numbers
match
, press the YES key and then press
ENTER. If the serial numbers do not match
,the
wrong personality parameter file is installed.
Refer to the Program Loader documentation for
instructions on reloading the personality
parameter file.
Menu 20—Factory Setup
Menu 20 Displays with Key Entries
Key
Entry Display Description
Input a menu number.
MENU 20
FACTORY SETUP
FINAL ASSEMBLY DATE
DD/MM/YY
MAIN MENU NUMBER 20
ENTER MENU NO. 1--15
Press the Enter key.
Displays the menu number and name.
Displays the final assembly date at the factory.
FINAL ASSEMBLY
CLOCK NO #
Displays the final assembly clock number at the factory.
OPERATING DAYS #
Displays the generator set operating days.
MODEL NO #
Displays the generator set model number.
SPEC NO #
Displays the generator set specification number.
GENSET SERIAL NO #
Displays the generator set serial number.
ALTERNATOR PART NO #
Displays the alternator part number.
ENGINE PART NO #
Displays the engine part number.
TEMP SENSOR YES
GM31045-X
TEMP SENSOR NO
GM16787
TEMP SENSOR NO
GM17362
SERIAL NO CONFIRM
Displays the generator set serial number confirmation display.
CONFIRM SERIAL? Y/N
######
Press YES, if the display matches the generator set nameplate serial
number. Refer to the Menu 20 NOTE above if the serial numbers do
not match.
Press the Enter key.
CONFIRM SERIAL? YES
######
Returns user to the Serial No. Confirm display.
SERIAL NO CONFIRM