Filter
Top Products
TP-6200 10/12112 Section 2 Operation
Local Programming Mode On
Menu 10—Output Setup, continued
Menu 10 Displays with Key Entries
Indicates whether the previously user-defined analog RDO was
selected (yes or no) as a low shutdown fault.
RELAY DRV OUT 01 Y/N
A01 LO SHUTDOWN→
Key
Entry Display Description
OR
Press the Enter key.
Confirms the entry.
Confirms the entry.
RELAY DRV OUT 01 YES
A01 LO SHUTDOWN→
RELAY DRV OUT 01 YES
A01 LO SHUTDOWN→
RELAY DRV OUT 01 NO
A01 LO SHUTDOWN→
RELAY DRV OUT 01 NO
A01 LO SHUTDOWN→
Press the Enter key.
Indicates whether the previously user-defined analog RDO was
selected (yes or no) as a high shutdown fault.
RELAY DRV OUT 01 Y/N
A01 HI SHUTDOWN→
OR
Press the Enter key.
Confirms the entry.
Confirms the entry.
RELAY DRV OUT 01 YES
A01 HI SHUTDOWN→
RELAY DRV OUT 01 YES
A01 HI SHUTDOWN→
RELAY DRV OUT 01 NO
A01 HI SHUTDOWN→
RELAY DRV OUT 01 NO
A01 HI SHUTDOWN→
Press the Enter key.
Entering YES adds the low shutdown selection to the defined analog
RDO group.
RELAY DRV OUT 01 NO
A01 LO SHUTDOWN→
RELAY DRV OUT 01 YES
A01 LO SHUTDOWN→
Entering NO removes the low shutdown selection from the defined
analog RDO group.
Entering YES adds the high shutdown selection to the defined analog
RDO group.
RELAY DRV OUT 01 NO
A01 HI SHUTDOWN→
RELAY DRV OUT 01 YES
A01 HI SHUTDOWN→
Entering NO removes the high shutdown selection from the defined
analog RDO group.
RELAY DRV OUT 01 Y/N
A01 LO WARNING→
Returns the user to the analog RDO (analog inputs) heading. Press
the Menu Down key to continue to the next selection A02--A07
(repeat as necessary).
Gives the user the option to add or delete a selection for the next
analog RDO. Note: Use the A01 analog RDO setup procedure
shown above for A02--A07. Go to
RELAY DRV OUT 01 Y/N
Axx
(see Group D) LO
WARNING→
ANALOG INPUTS →
Returns the user to the analog inputs heading. Press the Menu Right
key.
RELAY DRV OUT 01 →
(user defined)
Returns the user to the RDO 01 heading.
Gives the user the option to add or delete a selection for the next
RDO. Note: Use the RDO 01 setup procedure shown above for
RDOs 02--31. Go to
RELAY DRV OUT XX →
(user defined)