TP-6200 10/12 125Section 2 Operation
Local Programming Mode On
2.8.13 Menu 13—Communications
Menu 13 enables communication with the controller for
monitoring or controlling the generator set. KBUS allows
a variety of connection types while Modbusr follows
Modbusr RTU protocols. Use the LAN (local area
network) to gain remote access to multiple
devices/addresses. Use the KBUS enable local
programming mode to edit displays in this menu. Use
the monitor software operation manual when accessing
this menu, programming from a remote location, and
determining address and system identification
information.
The user must enable the programming mode to edit the
display.
See Section 2.6 for descriptions of the different types of
connections.
Modbusr is a registered trademark of Schneider
Electric.
The user must enable local programming to make
changes in Menu 13; see Section 2.8.14. After the
communications settings have been appropriately
entered, set the programming mode to REMOTE to
utilize remote programming.
Menu 13—Communications
Menu 13 Displays with Key Entries
Key
Entry Display Description
Input a menu number.
MENU 13
COMMUNICATIONS
Displays the KBUS protocol heading.
PROTOCOL →
KBUS
KBUS ONLINE Y/N
Displays the KBUS online selection.
Press the Enter key.
Confirms the entry.
Confirms the entry.
Press the Enter key.
KBUS ONLINE YES
KBUS ONLINE YES
KBUS ONLINE NO
KBUS ONLINE NO
OR
MAIN MENU NUMBER 13
ENTER MENU NO. 1--15
Press the Enter key.
Displays the menu number and name.
Entering YES activates the online KBUS selection.
KBUS ONLINE NO
Entering NO deactivates the online KBUS selection.
KBUS ONLINE YES