Filter
Top Products
Selecting a Preset Power Level Sweep Range
There are five preset power level sweep range pa
-
rameters selectable in the power level sweep modes.
These preset power level sweep range parameters
are L1-L2, L3-L4, L5-L6, L7-L8, and L9-L0.
To select one of the preset power level sweep ranges
from a Level Sweep menu, press the Level Control >
soft-key. The Level Sweep Control menu (below) is
displayed.
In addition to letting you select one of the preset
sweep ranges for the power level sweep, this menu
lets you select logarithmic or linear power level
sweep and set the start and stop power level param-
eters for each selected preset sweep range.
Setting a Preset Power Level Sweep Range
At the Level Sweep Control menu, select the power
level sweep range (L1-L2, L3-L4, L5-L6, L7-L8,or
L9-L0) that you wish to set. The menu then displays
the current frequency parameters for the selected
power level sweep range. Now, use the menu edit
soft-keys to open the power level parameters for ed
-
iting.
Edit the current power level parameter values or
enter new power level parameter values for the
power level sweep range. To close the open power
level parameter when you are finished, press its
menu edit soft-key or make another menu selection.
Selecting Type of Power Level Sweep
Press Units> [LOG/LIN] to display the Units menu
(left) and to select the power level units. When Log
is selected, units are dBm or dBmV; when Linear is
selected, units are mV. The units are displayed with
the indicated power level to reflect your selection
3-60 MG369XB OM
Power Level Sweep Operation Local (Front Panel) Operation