Filter
Top Products
3-7 CW Frequency
Operation
One of the signal generator's major functions is to produce discrete
CW frequencies across the frequency range of the instrument. The fol
-
lowing paragraphs describe how to place the MG369XB in the CW fre
-
quency mode, select a CW frequency and power level for output, and
activate the CW ramp and Phase Offset menus and functions. Use the
CW Frequency Mode menu map (Chapter 4, Figure 4-2) to follow the
menu sequences.
Selecting CW
Mode
To place the MG369XB in the CW frequency mode,
press Frequency . At the resulting menu display,
press CW . The CW menu (below) is displayed.
This menu lets you perform the following:
q
Select a CW frequency for output
q
Copy the current frequency and power level in-
formation to the current list index. (Refer to
page 3-42 for the list sweep frequency mode op
-
erating instructions)
q
Access the master-slave menu. (Refer to
page 7-4 for Master-Slave mode operating in
-
structions)
q
Select an output power level for the CW fre
-
quency
q
Select the Phase Offset menu
q
Select the CW Ramp menu
Selecting a
CW Frequency
There are several ways to select a CW frequency for
output. You can (1) edit the current frequency, (2)
enter a new frequency, or (3) select one of the 20 pre
-
set frequency parameters.
3-20 MG369XB OM
CW Frequency Operation Local (Front Panel) Operation
NOTE
When the signal generator is reset,
it automatically comes up operat
-
ing in the CW frequency mode.