Filter
Top Products
Step 3. Connect the special AUX I/O interface ca
-
ble (Anritsu Part No. 806-97) to the
MG369XB rear panel AUX I/O connector.
Connect the cable end having BNC con
-
nectors as follows:
a. Connect the cable end labeled “SEQ
SYNC” to the HP8757D rear panel
POS Z BLANK connector.
b. Connect the cable end labeled “SWP
DWELL IN” to the HP8757D rear
panel STOP SWEEP connector.
c. Connect the cable end labeled “HORIZ
OUT” to the HP8757D rear panel
SWEEP IN0-10Vconnector.
Setting Up the
MG369XB
The MG369XB must be set to GPIB address 19 and
in the 8757D Scalar mode of operation to operate as
a signal source for the SNA. The following para-
graphs describe how to set up the MG369XB to en-
able the 8757D Scalar GPIB mode.
On the MG369XB front panel, press Line to place
the signal generator in operation.
Allow the signal generator to warm up, then press
the System main menu key. At the System menu
display, press Config . The System Configuration
menu (below) is displayed.
At the System Configuration menu, press GPIB .
7-16 MG369XB OM
Use with a HP8757D Scalar Network Analyzer Use With Other Instruments