Filter
Top Products
Configuring
the RF
Configuring the RF of the MG369XB involves the
following:
q
Selecting RF on or off during retrace
q
Selecting RF on or off during frequency
switching in CW, step sweep, and list sweep
modes
q
Selecting whether a sweep triggered by a sin
-
gle or external trigger should rest at the top or
bottom of the sweep ramp
q
Selecting RF on or off at reset
q
Setting the reference multiplier value for fre
-
quency scaling
q
Selecting 40 dB or 0 dB of attenuation when
RF is switched off (units with a step attenu
-
ator, Option 2, installed)
To access the Configure RF menu (below) from the
System Configuration menu, press RF > .
Press Retrace RF to select RF on [RT1] or off [RT0]
during retrace. The display will reflect your selec
-
tion.
Press Delta-F RF to select RF on [RC1] or off [RC0]
during frequency switching in CW, step sweep, and
list sweep modes. The display will reflect your selec
-
tion.
Press Ramp Rest to select 0 or 10 for the ramp rest
point for sweeps that are triggered by a single trig
-
ger or external trigger. 0 indicates that the sweep
will rest at the bottom of the sweep ramp; 10 indi
-
cates that the sweep will rest at the top of the sweep
ramp. The display will reflect your selection.
Press Reset State to select RF on [RO0] or off [RO1]
at reset. The display will reflect your selection.
MG369XB OM 3-79
Local (Front Panel) Operation System Configuration