Filter
Top Products
Chapter 7
Use With Other Instruments
7-1 Introduction This chapter provides information and instructions for using the Se
-
ries MG369XB Synthesized signal generator with other instruments.
It contains the following:
q
Instructions for interconnecting and operating any two
MG369XB instruments in a master-slave configuration
q
Instructions for connecting the MG369XB to a Anritsu Model
56100A Scalar Network Analyzer so that it can be used as a sig
-
nal source for the analyzer
q
Instructions for connecting the MG369XB to a Anritsu Model
360B Vector Network Analyzer so that it can be used as a signal
source for the analyzer operating in the tracking receiver mode
q
Instructions for connecting a MG369XB that has pulse modula-
tion installed to a Giga-tronics Model 8003 Scalar Network Ana-
lyzer and setting up the signal generator so that it can be used as
a signal source for the analyzer
q
Instructions for connecting a MG369XB that has the pulse option
installed to a Hewlett Packard Model 8757D or 8757E Scalar
Network Analyzer and setting up the signal generator so that it
can be used as a signal source for the analyzer
q
Instructions for connecting and operating Option 7
q
Instructions for connecting and operating mmWave Source
Modules
NOTE
When the MG369XB is installed with a digital
down converter (Option 4), the analog sweep
capability is limited to ³500 MHz.
MG369XB OM 7-3