Filter
Top Products
7-4 Use with a 8003
Scalar Network
Analyzer
The MG369XB signal generator is compatible with the Giga-tronics
Model 8003 Scalar Network Analyzer (SNA). The following para
-
graphs provide instructions for connecting the MG369XB to the 8003
SNA and setting up the signal generator so that it can operate as a
signal source for the analyzer. Operating instructions for the scalar
network analyzer can be found in the Giga-tronics Model 8003 Scalar
Network Analyzer Operation Manual.
Connecting
the MG369XB
to the 8003
Connect the MG369XB signal generator to the 8003
scalar network analyzer as shown in Figure 7-3.
Step 1. Connect one end of a GPIB cable to the
MG369XB rear panel IEEE-488 GPIB con
-
nector. Connect the other end of the cable
to the 8003 rear panel GPIB/ PRIVATE
connector.
Step 2. Connect the special AUX I/O interface ca
-
ble (Anritsu Part No. 806-90) to the
MG369XB rear panel AUX I/O connector.
Connect the cable end having BNC con
-
nectors as follows:
a. Connect the cable end labeled “SEQ
SYNC” to the 8003 rear panel
BLANKING INPUT connector.
Use With Other Instruments Use with a 8003 Scalar Network Analyzer
MG369XB OM 7-11
M G 3 6 9 X B
S i g n a l G e n e r a t o r
8 0 0 3 S c a l a r
N e t w o r k A n a l y z e r
S e n s o r
G P I B /
P R I V A T E
B L A N K I N G I N P U T
A C M O D O U T
S W E E P I N
H O R I Z O U T
P U L S E T R I G G E R I N
S E Q S Y N C
I E E E - 4 8 8
G P I B
CA
B
T o D U T
T o D U T
A U X
I / O
Figure 7-3. MG369XB to 8003 SNA Connections