Filter
Top Products
Step 4. Connect the Master unit RF OUTPUT and
the Slave unit RF OUTPUT to the appro
-
priate connections on the DUT.
Initiating
Master-Slave
Operation
The following paragraphs describe how to set up
both instruments to perform master-slave opera
-
tions. Use the CW Frequency Mode menu map (Fig
-
ure 4-2, page 4-6) to follow the menu sequences.
To initiate master-slave operation, turn on both in
-
struments and place them in CW mode. The CW
menu (below) is displayed.
On the Master unit, press Master Slave > to access
the Master-Slave menu display (below).
This menu lets you perform the following:
q
Access the Slave Frequencies List menu
q
Set the delta frequency for the Slave unit
q
Set the Slave unit's main power level (L1)
q
Set the alternate sweep power level (L2) for
the Slave unit
q
Turn master-slave operation on and off
Press Slave Freqs... to access the Slave Frequencies
List menu (following page).
Use With Other Instruments Master-Slave Operation
MG369XB OM 7-5
NOTE
Master-slave operations are always
initiated in the CW frequency
mode. Once initiated, you then can
change to a sweep frequency mode
of operation by selecting the de-
sired frequencymode on the Master
instrument.