Filter
Top Products
To calibrate the internal power meter, connect the
RF detector to the MG369XB’s RF Output connector
and select Detector Cal > to enter the Detector Cali
-
bration menu (below).
From the Detector Calibration menu, press Start Cal
to begin the calibration (below).
After the calibration completes, the correction can
be enabled by pressing the Enable key. The status is
displayed in the Detector Calibration menu as On or
Off.
To disable the calibration correction, press Enable
again.
Press <Previous to return to the System menu.
To disable the power measurement function, press
Measure Power again.
3-118 MG369XB OM
Internal Power Meter (Option 8) Local (Front Panel) Operation