Filter
Top Products
At the Configure GPIB menu, press More > to ac
-
cess the First Additional Configure GPIB menu (be
-
low).
At this menu, press Emulation > to access the Sec
-
ond Additional Configure GPIB menu (below).
Press 8003 Scalar to enable the 8003 Scalar GPIB
mode. The display will reflect your selection.
The MG369XB signal generator is now ready to op
-
erate as a signal source for the 8003 SNA.
Initiating
8003 SNA
Operation
To initiate SNA operation, turn ON the Model 8003
and calibrate a 8003 sensor(s). (Refer to the Model
8003 Scalar Network Analyzer Operation Manual
for the calibration procedure.)
Use the following procedure to set the 8003 Source
Address to “5”. (The default address is “6”.)
Step 1. On the 8003 front panel, press the
CONFIG key.
Step 2. Select GPIB DEVICES from the menu dis
-
played on the CRT screen.
Use With Other Instruments Use with a 8003 Scalar Network Analyzer
MG369XB OM 7-13