Filter
Top Products
To replace the line fuse, proceed as follows:
Step 1. Turn off the rear panel power switch and
disconnect the MG369XB from the power
source.
Step 2. Using a small flat-blade screwdriver,
carefully pry under the tab next to the
rear panel power switch to open the cover
and gain access to the fuse holders (refer
to Figure 6-1, below).
Step 3. Slide out the fuse holders.
Step 4. Replace the fuses in the fuse holders.
Step 5. Install the fuse holders in the rear panel.
Step 6. Close the cover to secure the fuse holders
in place. It will close with an audible
snap.
Step 7. Reconnect the signal generator to the
power source and turn on the rear panel
power switch.
Operator Maintenance Routine Maintenance
MG369XB OM 6-15/6-16
Figure 6-1.
Replacing the Line Fuse