Filter
Top Products
2-6 Preparation for
Storage/Shipment
The following paragraphs give instructions for preparing the
MG369XB for storage or shipment.
Preparation
for Storage
Preparing the signal generator for storage consists
of cleaning the unit, packing the inside with mois
-
ture-absorbing desiccant crystals, and storing the
unit in a temperature environment that is main
-
tained between –40°C and +75°C.
Preparation
for Shipment
To provide maximum protection against damage in
transit, the signal generator should be repackaged
in the original shipping container. If this container
is no longer available and the unit is being returned
to Anritsu for repair, advise Anritsu Customer Ser
-
vice; they will send a new shipping container free of
charge. In the event neither of these two options is
possible, instructions for packaging and shipment
are given below.
Use a Suitable Container
Obtain a corrugated cardboard carton with a 125 kg
test strength. This carton should have inside dimen-
sions of no less than 15 cm larger than the unit di-
mensions to allow for cushioning (refer to
Figure 2-1, page 2-4).
Protect the Instrument
Surround the unit with polyethylene sheeting to
protect the finish.
Cushion the Instrument
Cushion the instrument on all sides by tightly pack
-
ing dunnage or urethane foam between the carton
and the unit. Provide at least three inches of dun
-
nage on all sides.
Seal the Container
Seal the carton by using either shipping tape or an
industrial stapler.
Address the Container
If the instrument is being returned to Anritsu for
service, mark the address of the appropriate Anritsu
service center (Table 2-1, following page) and your
return address on the carton in one or more promi
-
nent locations.
Installation Preparation for Storage/Shipment
MG369XB OM 2-13