Filter
Top Products
3-9 Fixed Power Level
Operation
The MG3692B provides main band leveled output power over a maxi
-
mum range of up to 32 dB (up to 135 dB with Option 2) for CW and
sweep frequency operations. Instruments with Option 15 provide lev
-
eled output power over a maximum range of up to 24 dB (up to 133 dB
with Option 2). The following paragraphs describe how to place the
signal generator in fixed (non-swept) power level mode, select a power
level for output, select logarithmic or linear units, and activate level
offset. Use the Fixed (Non-Swept) Power Level Mode menu map
(Chapter 4, Figure 4-7) to follow the menu sequences.
Selecting
Fixed Power
Level Mode
To place the MG369XB in a fixed power level mode
from a CW or sweep frequency menu, press Level .
At the resulting menu display, press Level . The
Level menu (below) is displayed.
This menu lets you perform the following:
q
Edit the power level parameter
q
Set the power level to 1 dB below specified
maximum leveled output power (CW only)
q
Edit the level offset parameter
q
Turn level offset on/off
Selecting a
Power Level
There are several ways to select a power level for
output. You can edit the current power level, enter a
new power level, or select one of the 10 preset power
level parameters.
Editing the Current Power Level
Press Edit L1 [XL1] to open the power level parame
-
ter, then edit the current power level using the cur
-
sor control keys or the rotary data knob. To close the
open power level parameter, press Edit L1 or make
another menu selection.
MG369XB OM 3-51
Local (Front Panel) Operation Fixed Power Level Operation