Filter
Top Products
Setting the
GPIB Address
The default GPIB address is five. If a different GPIB
address is desired, it can be set from the front panel
using the Configure GPIB menu.
To change the GPIB address, first press the front
panel main menu key labeled System . The System
menu is displayed.
Now press the menu soft-key Config . The System
Configuration menu (shown below) is displayed.
To access the Configure GPIB menu from this menu,
press the menu soft-key GPIB > . The Configure
GPIB menu (shown below) is displayed.
Press the menu soft-key GPIB Address [ADD] to
change the current GPIB address of the signal gen
-
erator. Enter a new address using the cursor control
keys or the data entry keypad and the terminator
soft-key [ADR]. The new GPIB address will now ap
-
pear on the display. The entry must be between 1
and 30 to be recognized as a valid GPIB address.
Installation GPIB Setup and Interconnection
MG369XB OM 2-11