Filter
Top Products
Editing the Current Power Level
Press Edit L1 [XL1] to open the power level parame
-
ter, then edit the current power level using the cur
-
sor control keys or rotary data knob. To close the
open power level parameter, press Edit L1 or make
another menu selection.
Entering a New Power Level
Press Edit L1 [XL1] to open the power level parame
-
ter, then enter the new power level using the keypad
and appropriate terminator key. To close the open
power level parameter, press Edit L1 or make an
-
other menu selection.
NOTE
You can also select any of the preset power lev
-
els or a power level sweep for a CW frequency.
For instructions, refer to Section 3-9 (Fixed
Power Level Operation) and Section 3-10
(Power Level Sweep Operation).
CW Ramp When active, the MG369XB's CW ramp provides a
repetitive 0V to 10V ramp output to the rear panel
HORIZ OUT BNC connector and AUX I/O connector,
pin 1. The CW ramp is used to drive a scalar ana-
lyzer display.
To turn on the CW ramp from the CW menu, press
CW Ramp> to access the CW Ramp menu (below)
and press CW Ramp [CS1].
While the CW ramp is on, the message
CW Ramp
appears on the right side of the frequency title bar
on all CW menus.
Press CW Ramp [CS0] again to turn the CW ramp
off.
MG369XB OM 3-23
Local (Front Panel) Operation CW Frequency Operation