Filter
Top Products
To select one of the preset sweep ranges from any
sweep frequency mode menu, press the soft-key
Frequency Control > . The Sweep Frequency Control
menu (below) is displayed.
This menu lets you perform the following:
q
Select a full range sweep (F
min
to F
max
) [FUL]
or one of the preset sweep ranges for the sweep
frequency mode
q
Select the frequency parameters for each pre-
set sweep range
q
Access the marker list menu (described on
page 3-36)
q
Select an output power level for the sweep
Setting a Preset Sweep Range
At the Sweep Frequency Control menu, select the
sweep range (F1-F2, F3-F4, F5-dF,orF6-dF) that you
wish to set. The menu then displays the current fre
-
quency parameters for the selected sweep range.
Now, use the menu edit soft-keys to open the fre
-
quency parameters for editing.
Edit the current frequency parameters or enter new
frequency parameter values for the sweep range. To
close the open frequency parameter when you are
finished, press its menu edit soft-key or make an
-
other menu selection.
You can set all the preset sweep ranges in this man
-
ner.
MG369XB OM 3-35
Local (Front Panel) Operation Sweep Frequency Operation