Filter
Top Products
Stepped Delay Mode
The Stepped Delay Mode lets you automatically in
-
crement or decrement the Pulse Delay 1 (D1) value
according to step delay parameters. The mode is
only available when the Delayed or Triggered w/de
-
lay triggering mode is selected. Selecting either trig
-
gering mode adds the soft-key Step Delay > to the
Internal Pulse Status menu. Refer to page 3-110 for
setting the triggering options.
From the Internal Pulse menu, press Step Delay >
to access the Step Delay Mode menu (below).
This menu allows you to perform the following:
q
Turn step delay on/off
q
Edit the step delay parameters
q
Set the length of time a Delay 1 (D1) time is
applied before it is incremented or decrement
-
ed by the step size
Open the parameter you wish to change, then edit
the current value using the cursor control keys or
the rotary data knob or enter a new value using the
key pad and appropriate termination key. When you
have finished setting the open parameter, close it by
pressing its menu soft-key or make another menu
selection.
Press On/Off to turn the Stepped Delay Mode on
and off.
Press Start Delay to open the Delay 1 (D1) start
time parameter.
Press Stop Delay to open the Delay 1 (D1) end time
parameter.
MG369XB OM 3-113
Local (Front Panel) Operation Signal Modulation
NOTE
If the set Step Delay parameters re
-
sult in a fractional number of incre
-
ments,then the last (fractional) one
is not taken.