Filter
Top Products
Power
Requirements
The signal generator accepts 90 to 264 Vac, 48 to
440 Hz, single-phase power. Power consumption is
300 VA maximum. The signal generator is intended
for Installation Category (Over Voltage Category) II.
Power
Connection
To connect the MG369XB to the power source, plug
the female end of the power cable into the input line
voltage receptacle on the rear panel (Figure 2-2).
Then plug the male end of the power cord into a
three-wire power line outlet. Turn on the rear panel
power switch. This automatically places the signal
generator in operation (front panel OPERATE LED
on).
Rack Mounting Kit Installation Installation
2-8 MG369XB OM
When supplying power to this equipment, always use a
three-wire power cable connected to a three-wire power line
outlet. If power is supplied without grounding the equip
-
ment in this manner, there is a risk of receiving a severe or
fatal electric shock.
WARNING
Figure 2-2. Signal Generator Rear Panel Showing Power Connection