Filter
Top Products
2-4 Rack Mounting Kit
Installation
The rack mounting kit (Option 1A) contains a set of track slides (90°
tilt capability), mounting ears, and front panel handles for mounting
the signal generator in a standard equipment rack. The following pro
-
cedure provides instructions for installing the rack mounting hard
-
ware on to the instrument. The rack mounting kit (Option 1B) uses
the same inner assembly without the slide. This procedure may also be
used for installing the Option 1B rack mount assembly. Refer to Fig
-
ures 2-3 and 2-4 during this procedure.
Preliminary Disconnect the power cord and any other cables
from the instrument.
Procedure Install the rack mounting hardware as follows:
Step 1. Using a Phillips screwdriver, remove the
screws and the front handle assemblies
from the instrument. (For instruments
not having front handles, remove the
screws and the front top and bottom feet
from the instrument.) Retain the screws.
Step 2. Remove the four feet from the rear of the
instrument. Retain the screws.
Installation Rack Mounting Kit Installation
MG369XB OM 2-5
Rear Feet
(4)
Figure 2-3. Front Handle and Feet Removal