Filter
Top Products
Editing the Current Start / Stop Frequencies
To edit the current frequency sweep range, open ei
-
ther the start or stop frequency parameter. In the
display above, Edit F1 [F1] opens the start fre
-
quency parameter; Edit F2 [F2] opens the stop fre
-
quency parameter.
Edit the open frequency parameter using the cursor
control keys or the rotary data knob. When you are
finished, close the open parameter by pressing its
menu edit soft-key or by making another menu se
-
lection.
Entering New Start / Stop Frequencies
To enter a new frequency sweep range, open either
the start or stop frequency parameter (press Edit F1
[F1] or Edit F2 [F2]).
Enter a new frequency using the keypad and appro-
priate termination soft-key. When you are finished,
close the open parameter by pressing its menu edit
soft-key or by making another menu selection.
Selecting a Preset Sweep Range
There are four preset sweep range parameters, se-
lectable in the analog sweep, step sweep, and man-
ual sweep frequency modes. The following is a
description of each preset sweep range.
q
F1-F2 [SF1] –provides a frequency sweep be
-
tween the start frequency, F1, and the stop fre
-
quency, F2
q
F3-F4 [SF3]–provides a frequency sweep be
-
tween the start frequency, F3, and the stop fre
-
quency, F4
q
F5-dF [DF5]–provides a symmetrical frequency
sweep about the center frequency, F5. The
sweep width is determined by the dF frequency
parameter
q
F6-dF [DF6]–provides a symmetrical frequency
sweep about the center frequency, F6. The
sweep width is determined by the dF frequency
parameter
3-34 MG369XB OM
Sweep Frequency Operation Local (Front Panel) Operation
RANGE
This error message is displayed
when the dF value entered results
in a sweep outside the range of the
MG369XB. Entering a valid value
will clear the error.