Filter
Top Products
Step 3. Remove the inner slide assemblies from
the outer slide assemblies.
Step 4. Place the left side inner slide assembly
onto the instrument case with the handle
towards the front of the instrument (Fig
-
ure 2-4).
Step 5. Insert two green-headed screws through
the holes in the slide assembly behind the
handle and into the metric tapped holes
in the side of the instrument.
Step 6. Insert two green-headed screws through
the holes near the rear of the slide assem
-
bly and into the metric tapped holes in
the side of the instrument.
Step 7. Insert the two SAE threaded screws (re
-
moved from the feet) through the 90° tabs
on the rear of the slide assembly and into
the rear panel of the instrument.
Step 8. Using the Phillips screwdriver, tighten all
screws holding the left side slide assem-
bly to the instrument chassis.
Rack Mounting Kit Installation Installation
2-6 MG369XB OM
NOTE
The screws with green heads have
metric threads. When it becomes
necessary to replace any of these
screws, always use the exact re
-
placement green-headed screws to
avoid damage to the instrument.
Anritsu P/N’s: 905-8 (long);
Z-951102 (short).
Figure 2-4. Rack Mounting Hardware Installation