Filter
Top Products
Selecting the
Line
Terminator
Data is delimited on the GPIB by either the carriage
return (CR) ASCII character or both the carriage re
-
turn and line feed (CR/LF) ASCII characters. Which
character is used depends upon the requirements of
the system controller. Most modern controllers can
use either CR or CR/LF, while many older control
-
lers require one or the other. Consult the controller's
manual for its particular requirements.
From the Configure GPIB menu display, you can se
-
lect which GPIB terminator to use by pressing the
menu soft-key GPIB Terminator . This menu soft-key
toggles the GPIB terminator between CR and
CR/LF. The current selection appears on the display.
Interface
Language
The series MG369XB synthesized signal generators
can be remotely operated via the GPIB using an ex
-
ternal interface language—Native. The Native in
-
terface language uses a set of MG369XB GPIB
product specific commands to control the instru-
ment. Detailed descriptions and a comprehensive
list of these commands can be found in the
MG369XB programming manual, P/N: 10370-10366.
GPIB Setup and Interconnection Installation
2-12 MG369XB OM