Filter
Top Products
MG369XB
Mixer Setup
Set up the MG369XB as follows:
Step 1. Connect the MG369XB RF output to the
MG369XB rear panel LO input.
Step 2. Connect an IF source output to the
MG369XB rear panel IF input.
Step 3. Set the MG369XB power level to
+13 dBm.
Step 4. Set the desired up-conversion frequency
on the MG369XB.
Step 5. Connect the MG369XB rear panel mixer
RF output to your transmission channel.
The MG369XB is now configured to up-convert the
IF input to the microwave frequency set on the in
-
struments front panel display.
7-20 MG369XB OM
IF Up-Conversion (Option 7) Use With Other Instruments
AUX I/O
10 Mhz
REF IN
HORIZ
OUT
PULSE
TRIG
IN
10 Mhz
REF
OUT
EXT
ALC
IN
SERIAL
I/O
IEEE-488 GPIB
IF
RF
LO
RF Output
AUX I/O
IEEE-488 GPIB
IF
RF
LO
RF Output
Figure 7-6. MG369XB Rear Panel IF Up-conversion Connectors.