Filter
Top Products
Place both instruments in CW mode. Then, on the
Master unit, press Master Slave > to access the
Master Slave menu display.
At the Master Slave menu, press Slave Freqs... to
access the Slave Frequencies List menu display (be
-
low).
Press VNA > to access the VNA menu display (be-
low).
This menu lets you set the frequency offset and out
-
put power level for the Slave instrument in the VNA
mode.
Press VNA Offset to open the slave frequency offset
parameter.
Press VNA Level to open the slave output power
level parameter.
Open the parameter you wish to change, then edit
the current value using the cursor control keys, ro
-
tary data knob, or enter a new value using the key
pad and appropriate termination key. When you
have finished setting the open parameter, close it by
pressing its menu soft-key or by making another
menu selection.
7-8 MG369XB OM
Master-Slave Operation Use With Other Instruments