Filter
Top Products
3-6 Entering Data Before proceeding to the various modes of signal generator operation,
you need to know how to enter data from the front panel. Entering
data refers to changing a parameter's value by editing its current
value or entering a new value to replace the current value. The follow
-
ing instructions describe how to (1) open a parameter, (2) edit its cur
-
rent value, and (3) enter a new value.
A typical MG369XB menu display (below) is used throughout the data
entry instructions. At this menu display, you can edit both the CW fre
-
quency and the output power level parameters.
If you wish to follow along on your MG369XB, you can obtain this
same menu display by resetting your instrument (press System , then
press Reset ).
Opening the
Parameter
In order for the value of a parameter to be changed,
the parameter must first be opened.
To open the frequency parameter from the above
menu, press Edit F1 . The menu display changes
(below) to show that the menu soft-key Edit F1 has
been pressed and that the frequency parameter has
been opened. An open parameter is indicated by
placing it in a window with a movable cursor under
its digits. If the cursor is not displayed, you must de
-
activate increment mode (refer to page 3-84).
MG369XB OM 3-17
Local (Front Panel) Operation Entering Data