Filter
Top Products
Reelmaster 3550−DPage 1 − 4Safety
Jacking Instructions
CAUTION
When changing attachments, tires or perform-
ing other service, use correct jacks and sup-
ports. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to
raising machine, remove any attachments that
may interfere with the safe and proper raising of
the machine. Always chock or block wheels. Use
jack stands to support the raised machine. If the
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
Jacking the Front End
1. If the front wheel or wheel motor is to be removed,
position jack securely under the round tube of the lower
frame as closely to the side plate as possible.
2. Use appropriate jack stands under the round tube to
support the machine.
Jacking the Rear End
1. Chock both front wheels.
IMPORTANT: Make sure jack is as close to the rear
fork as possible when raising the machine.
2. Place jack securely under the rear lift arm support as
close to the fork as possible. Raise rear tire off the
ground.
3. Use appropriate jack stands under the frame to sup-
port the machine.