Filter
Top Products
Reelmaster 3550−D
Cutting Units
Page 7 − 16
5. Remove caps or plugs from fittings and hoses.
IMPORTANT: When installing the hydraulic hoses,
make sure that hydraulic hoses are straight (not twisted)
before tightening the hoses to the motor fittings.
6. Lubricate and install new O−rings on motor fittings.
Correctly connect hydraulic hoses to the motor using la-
bels placed during removal procedure.
7. Check oil level in hydraulic reservoir and add correct
oil if necessary.
8. Follow Hydraulic System Start−up procedures (see
Hydraulic System Start−up in this section).