Filter
Top Products
Reelmaster 3550−D GroomerPage 8 − 13
5. If groomer reel is equipped with broomer kit:
A. Slide a brush into each groove around the full
length of the groomer reel (Fig. 11). Make sure
brushes are seated in groomer blade slots (Fig. 12)
B. Loosely wrap the straps around the groomer reel
shaft and brushes as shown (Fig. 11). Straps should
be positioned between blades 1−2, 11−12, 21−22
and 31−32.
IMPORTANT: The straps must be wrapped
around the groomer blade and brush assembly
in the correct direction.
C. Pull straps tight and cut off strap extension ap-
proximately 1/4” (6 mm) beyond retainer.
6. Place excluder seals on groomer shaft.
7. Install O−ring on non−drive end of groomer shaft.
8. Install groomer reel back on cutting unit (see
Groomer Reel Installation in this section).
1. Groomer reel 2. Broomer strap (4)
Figure 11
FORWARD
1
2
2
1. Brush 2. Blade
Figure 12
ROTATION
1
2
Groomer