Filter
Top Products
Reelmaster 3550−D
Cutting Units
Page 7 − 27
NOTE: The parallel position of the rear roller to the cut-
ting reel is controlled by the precision machined frame
and side plates of the cutting unit. If necessary, the cut-
ting unit side plates can be loosened and a slight adjust-
ment can be made to parallel the rear roller with the
cutting reel (see Leveling Rear Roller in this Chapter).
13.If cutting unit is equipped with optional groomer or
rear roller brush, install components for those options to
left hand side plate of cutting unit. See Chapter 8 −
Groomer for information on groomer. See Rear Roller
Brush in this chapter for information on rear roller brush.
14.If counterweight was removed from cutting unit,
install new O−ring on counter weight. Secure counter
weight to cutting unit side plate with two (2) flange nuts.
Torque screws from 27 to 33 ft-lbs (37 to 44 N−m).
15.Install cutting unit to the machine.
DPA Cutting
Units