Tutorials
AWG610 Arbitrary Waveform Generator User Manual
2-59
Figure 2-38: Waveform created with the multiply operation
Do the following steps to save the waveform:
NOTE. To output the waveform in the waveform editor, you must first save the
waveform into a file and then load the file into the waveform memory.
1. Push the File bottom button.
The File pop-up menu appears.
2. Select Save from the pop-up menu using the general purpose knob.
3. Push the OK side button.
The Input Filename dialog box appears, as shown in Figure 2–39. Note that
.wfm is displayed in the file name field.
4. Push the SHIFT button on the front-panel.
The SHIFT LED is on.
This operation lets you input uppercase characters with the keypad. The
SHIFT LED goes off when the Input File Name dialog box disappears.
Save the Waveform